Mechanical Installation
‑25‑
Removing the battery box
The battery may generate leakage liquid after long‑term use. Replace it every two
years. Remove the battery box in steps shown in the preceding figure, but in the
reverse order.
When closing the battery box cover, prevent the connector cable from being pinched.
Improper use of the battery may result in liquid leakage which corrodes the
components or leads to battery explosion. Observe the following precautions during
use:
● Insert the battery with polarity (+/‑) placed correctly.
● Leaving an idled or retired battery inside the device may lead to electrolyte
leakage. The electrolyte inside the battery is highly corrosive, not only corroding
surrounding components but also incurring the risk of short circuit. It is
recommended to replace the battery every 2 years.
● Do not disassemble the battery because the internal electrolyte may spread out
and result in personal injury.
● Do not throw a battery into the fire. Failure to comply may result in an explosion.
● Do not short‑circuit the battery or strip off the battery case. Prevent terminals (+)
and (‑) of the battery from coming into contact with the metal. Contact with the
metal can result in a high current, not only weakening the battery power, but also
incurring the risk of explosion due to severe heating.
● This battery is not rechargeable.
● Dispose of the retired battery according to local regulations.
To Next Page
Loading...
