ISTRUZIONI PER L’UTENTE
INSTRUCTIONS FOR THE USER
ANLEITUNGEN FÜR DEN BENUTZER
Combination ovens with direct and boiler system, gas and electric models. Programmable panel
17
6.6 SETTING OF THE PHASE “COMBINATION FOR REGENERATION” AND STARTING IN THE MANUAL COOKING PROGRAM N°4
(Fig.
6.5 it)
This program is manual and is made up of a single phase, having the name corresponding to the cooking mode convection with hot forced air ,
particularly suitable to regenerate precooked frozen food. By turning the encoder-knob on the program 4, the electronic system will show:
1 on the LCD display (A) the data relating to the last cooking done using Program 4;
2 on the back lighted display (L) the set temperature for about 5 seconds, then the message
Go
before showing the real cooking chamber
temperature;
3 on the back lighted display (N) the cooking time of the last steam cycle done. If in the last cooking cycle the core probe has been used, the
display (N) will be switched off;
4 on the back lighted display (O) the temperature selected for the core probe if in the last cooking cycle the core probe was used , vice versa the
display (O) will be switched off.
5 On the back lighted display (M) the percentage of humidification used for the last combination cooking program.
If the door of the oven is open on the display (N) you will see the message
oPn.
If you want to select a cooking program, maintaining the same values shown on the display, you just need to press the button START/STOP to start the
cycle. The flashing of the temperature value means that the programming
has begun.
6.6A Modification cooking chamber temperature
The value shown on the display (L) is that one of the cooking chamber
temperature and it can be selected between 120°C and 160°C; if you select
low speed of fan the maximum temperature will be instead
220°C.
To modify the value (L) please act as follows:
- press the encoder Knob (B);* the value will flash;
- select the new value, by turning the encoder knob (B),
clockwise to increase it and counter clockwise to decrease it.
Press the encoder knob to memorize the selected value and let the electronic
system move to the following programming of the temperature core probe on
the display (O).
6.6B Modification core probe temperature
As described on the paragraph 6.3 B.
6.6C Activation of the function
Δ
t (Delta T)
As described on the paragraph 6.3 B.
6.6D Modification cooking time
As described on paragraph 6.3 B.
6.6E Modification percentage of humidity
As described on paragraph 6.5E.
Fig.6.6 uk
To Next Page
Loading...