www.insigniaproducts.com
21
NS-RFD26SS9
3 Connect the 1/4" extension tubing (included) to the shutoff valve.
4 Turn the main water supply back on, then turn on the shutoff valve and flush out the tubing until the water runs clear.
5 Turn off the shutoff valve.
6 Connect the extension tubing to the water connector on the back of your refrigerator and to the coupler. Make sure
that you fully insert the extension tubing into the coupler and that the tubing is not bent or pinched. Insert a clip
(included) onto the coupler to lock the tubing in place.
7 Connect the extension tubing to the water line in the same way and secure the tubing with a clip (included).
8 Turn on the water and check for any leakage.
9 After you are sure that water is connected correctly, let the water run for about five minutes to flush the water filter.
Note: The initial dark discoloration of water is normal.
Note: The first time you use the water dispenser, you may hear the sound of water pushing air out of the water dispenser. This is
normal.
To Next Page
Loading...
