Installation:
1. The Wind Guard is installed by
default. Remove the Wind Guard
by sliding it to the right to expose
the red indication mark, then
remove it.
2. Align the Mic Cap with the
diagonal mark on the front of the
camera and hold it firmly against
the camera.
3. Slide the Mic Cap to the left
until it makes a clicking sound.
Ensure the red indication mark is
fully covered.
Removal:
1. Slide the Mic Cap to the right
to expose the red indication
mark, then remove it.
Notes:
1. Use the Mic Cap for
underwater or water sports
scenes.
2. Attaching and removing the
Mic Cap will not affect the
waterproofing of the camera
itself.
To Next Page
Loading...
