38 | support@instantpot.co.uk | +44 (0) 3331 230051
Care, cleaning and storage
Float valve and silicone cap
Remove the oat valve
Place one nger on the at top of the oat
valve, then turn the lid over. Detach the
silicone cap from the bottom side of the
oat valve. Remove the oat valve from
the top of the lid.
Do not discard the oat valve or
silicone cap.
Install the oat valve
Drop the narrow end of the oat valve into
the oat valve hole on the top of the lid.
Place one nger on the at top of the oat
valve, then turn the lid over. Firmly attach
the silicone cap to the bottom of the
oat valve.
Do not attempt to operate the pressure
cooker without having the oat valve and/
or silicone cap properly installed in the
pressure cooking lid.
Condensation collector
The condensation collector sits at the
back of the cooker base and catches any
overow from the condensation rim.
It should be installed before cooking, then
emptied and rinsed out after each use.
Remove the condensation collector
Pull the condensation collector away
from the cooker base; do not pull down.
Note the tabs on the cooker base and the
grooves on the condensation collector.
Install the condensation collector
Align the grooves on the condensation
collector over the tabs on the back of the
cooker base and slide the condensation
collector into place.
Illustrations in this document are for reference only and may differ from the actual product.
Always refer to the actual product.
To Next Page
Loading...
Need help?
General
