EasyManuals Logo

Instant Pot Duo Plus 30 v2 User Manual

Instant Pot Duo Plus 30 v2
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
40 | support@instantpot.co.uk | +44 (0) 3331 230051
Troubleshooting
Problem Possible reason Try this
Steam leaks from
side of lid.
No sealing ring in the lid. Fit a sealing ring.
The sealing ring is damaged or not
properly tted.
Replace the sealing ring.
Food debris attached to the sealingring. Remove the sealing ring and clean it thoroughly.
The lid is not closed properly. Open, then close the lid.
The sealing ring rack is warped
oroff-centre.
Remove the sealing ring from the lid, then check
the sealing ring rack for bends or warps. Contact
Customer Care.
The inner pot rim may be misshapen.
Check for deformation and contact
Customer Care.
The oat valve does
notrise.
Food debris on the oat valve or oat
valve silicone cap.
Remove the oat valve from the lid and clean it
thoroughly. Perform the Initial test run to check
operation and record your ndings. Contact
Customer Care.
Too little liquid in the inner pot.
Check for scorching on the bottom of the inner
pot. Add thin, water-based liquid to the inner
pot according to its size.
5.7 L: 375 mL
8 L: 500 ml
Float valve silicone cap is damaged
ormissing.
Install or replace the oat valve and/or silicone cap.
Float valve obstructed by lid-locking
mechanism.
Tap the oat valve with a long utensil. If the oat
valve does not drop, turn the multicooker off.
Contact Customer Care.
No heat in the inner pot.
Perform the Initial test run to check for
operation and record your ndings.
ContactCustomer Care.
Inner pot base may be damaged.
Perform the Initial test run to check for
operation and record your ndings. Contact
Customer Care.
Small amount of
steam leaking or
hissing from the
steam release
valve during the
cooking cycle.
Quick release switch is not in the
Seal position.
Move the quick release switch to the
Sealposition.
Multicooker is regulating excess
pressure.
This is normal; no action required.
The display
remains blank after
connecting the
power lead.
Bad power connection or no power.
Ensure power connection to base is tight
(5.7 Litres only).
Check socket to make sure it is powered.
Inspect power lead for damage. If damage is
noticed, contact Customer Care.
Multicooker’s electrical fuse has blown. Contact Customer Care.

Other manuals for Instant Pot Duo Plus 30 v2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Instant Pot Duo Plus 30 v2 and is the answer not in the manual?

Instant Pot Duo Plus 30 v2 Specifications

General IconGeneral
BrandInstant Pot
ModelDuo Plus 30 v2
CategoryElectric Pressure Cooker
LanguageEnglish

Related product manuals