21
Problem Possible Reason Soluon
1
Dicult to close the lid
Sealing ring not installed
properly
Posion the sealing ring
well
Float valve in the popped-up
posion
Press the oat valve lightly
downward
2
Dicult to open the lid
Pressure exists inside the
cooker
Posion the pressure re-
lease valve to the venng
posion to reduce the in-
ternal pressure. Open the
lid aer the pressure is
Float valve stuck at the
popped-up posion
Press the oat valve lightly
with a pen or chopsck.
3
Steam leaks from the
side of the lid
No sealing ring Install the sealing ring
Sealing ring damaged Replace the sealing ring
Food debris aached to the
sealing ring
Clean the sealing ring
Lid not closed properly
Open then Close the lid
again
4
Steam leaks from oat
valve for over 2 minutes
Food debris on the oat valve
silicone seal
Clean the oat valve sili-
cone seal
Float valve silicone ring worn-
out
Replace the oat valve sili-
cone ring
5
Float valve unable to
rise
Too lile food or water in
inner pot
Add water according to the
recipe
Float valve obstructed by the
lid locking pin
Close the lid completely,
see “Cooking Preparaon”
secon
6
Steam comes out from
exhaust valve non-stop
Pressure release handle not
in sealing posion
Turn the release handle to
the sealing posion
Pressure control fails Contact support online
7
Display ashes “Lid”
Lid is not in the correct posi-
on for the selected program
Close lid for pressure cook-
ing or open the lid for sau-
téing
8
Display shows “noPr”
Working pressure is not
reached during pre-heang
cycle.
If the lid leaks steam,
please see Problems 3, 4, 5
and 6. If there is no steam
leaking and you have frozen
food in the cooker, please
run the current program
again.
9
Display shows “Ovht”
Overheang is detected on
the inner pot
Please stop the program
and check if the food at the
boom of the inner pot is
burnt.
Troubleshoong Table
To Next Page
Loading...
