DSR-7.3
24
27
26
25
28
29
30
33
32
34
31
37
36
35
38
39
40
42
41
1
3
6
5
2
4
8
7
18
19
20
23
22
21
Audio button
Press repeatedly to select one of the audio languages programmed
on a DVD.
For Video CD and MP3, each press changes the audio output as
follows.
Stereo 1/L(Left) 2/R(Right)
Angle button
Some DVDs are recorded with various camera angle playback
options. Press Angle repeatedly to display different camera angles.
Last M button
You can resume DVD or Video CD playback from the point you last
watched even if the disc is removed from the DVD receiver. Press
Last M during playback to set a Last Memory Point. When you
want to resume playback of that disc, press Last M in the stop
mode and playback starts from the memorized point. Last Memory
locations can be stored for up to 5 DVDs and 1 Video CD.
Program button
You can program titles, chapters or tracks to play back in desired
order. Programs can be a maximum of 24 steps.
Number buttons (1-9, +10, 0)
Use to perform direct title/folder and chapter/track searches, and to
input numerical values. Press Mode Rcvr for additional functions
+10/--/--- button
Press to input numbers over 10.
Standby button [34, 43, 45, 62]
Put the DVD Receiver in standby.
Light button
Illuminates the buttons. This button is useful when using the
remote controller in dark locations. When pressed, the buttons on
the remote controller light green.
Clock button
Press to view the clock display.
Display button
Press to change the information being displayed.
Menu button
Use to display or close the DVD menu or MP3 Navigator screen.
VOL buttons
For adjusting the volume.
Setup button
Press when the DVD Receiver is in either play or stop mode to
open and close the Setup screen.
Muting button
Activates the mute function.
A. Control button
Press to change the acoustic mode to boost the super bass/high
frequency sounds.
button
Press to start or resume playback.
buttons
During playback of DVD and Video CD, press to perform fast
forward scanning or to perform fast reverse scanning of DVD
and Video CD. When a CD or MP3 is loaded, audio scanning is
performed.
A-B button
Press at the beginning and end of the section you want to repeat
or to mark a location you want to return to.
button
Press to pause disc playback. Press again to resume playback.
Timer button
Press to activate a timer function or to set a timer program.
FM Mode button
For AM/FM input, press to switch between FM Stereo auto and
mono.
Subtitle button
Press repeatedly to select one of the subtitle languages
programmed on DVD or to turn the subtitles off.
Clear button
Works in conjunction with a number of player functions. Use to
cancel repeat and random playback, and to edit programs.
Random button
Press to play chapters/tracks in random order.
Search/Enter button
Press to perform a title/folder, chapter/track or elapsed time
search. Press to confirm when controlling a connected TV.
Press Mode Recvr to use the following (gray) buttons
Other buttons have the same functions as when Mode DVD
button is pressed.
SP Setup button
Press to select the optimum speaker configuration.
SW Mode button
Press to select the subwoofer mode.
Distance button
For setting the distances for each speaker.
IPM (Intelligent Power Management) button
Activates the IPM function.
T-D Setup
For setting the T-D parameters.
CH Sel button
Selects a speaker for changing the speaker output level.
Test Tone button
Outputs a test tone for setting speaker levels.
Up/Down buttons
Press to adjust the value.
T
-
D Setup
IPM
SW Mode
Distance
--
/
---
Enter
Up/
Down
SP Setup Test Tone CH Sel
RC
-
507
M
123
456
+
10
Search
0
789
1
3
6
5
2
4
8
7
REMOTE CONTROLLER-2
RC-507M
www.denom.com
To Next Page
Loading...
Need help?
General
