Intel 1037U

29
EUP Support
The optional settings: [Enabled]; [Disabled].
Use this item to enable or disable EUP function for this board.
This item should be set as [Disabled] if you wish to have active all Wake-up
functions.
Wake-Up by PCIE/LAN from S5
The optional settings: [Enabled]; [Disabled].
*This item will only show when ‘EUP Support’ is set as [Disabled].
PWRON After PWR-Fail
The optional settings: [Former-Sts]; [Always On]; [Always Off].
 RTC Wakeup Settings
Press [Enter] to make settings for the following sub-items:
Wake System with Fixed Time
The optional settings: [Enabled]; [Disabled].
Use this item to enable or disable system wake on alarm event. When set as
[Enabled], system will wake on the hour/min/sec specified.
Wake System with Dynamic Time
The optional settings: [Enabled]; [Disabled].
Use this item to enable or disable system wake on alarm event. When set as
[Enabled], system will wake on the current time + increased minute(s).
 SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
Use this item to enable or disable SATA device.
The optional settings: [Enabled]; [Disabled].
SATA Mode Selection
Use this item to determine how SATA controller(s) operate.
The optional settings are: [IDE]; [AHCI].
Smart Self Test
Use this function to run SMART self test on all HDDs during POST.
The optional settings: [Enabled]; [Disabled].
IDE Legacy / Native Mode Selection
The optional settings are: [Native]; [Legacy].