35
North Bridge Configuration
Press [Enter] to make settings for the following sub-items:
DMI Gen 2
The optional settings are: [Auto]; [Enabled]; [Disabled].
VT-D
The optional settings are: [Enabled]; [Disabled].
*This item might not be available depending on configuration.
IGD Memory
Use this item to select DVMT 5.0 pre-allocated (fixed) graphics memory size used
by the internal graphics device.
The optional settings are: [64M]; [96M]; [128M];[160M];[192M]; [224M]; [256M];
[288M];[320M];[352M];[384M];[416M];[448M];[480M;][512M].
DVMT Total Gfx Mem
Use this item to select DVMT 5.0 total graphics memory size used by the internal
graphics device.
The optional settings are: [128M]; [256M]; [MAX].
RC6(Render Standby)
Use this item to enable or disable render standby support.
RC6+(Deep RC6)
Use this item to enable or disable render deep RC6 (RC6+) support.
IGFX Boot Display
Use this item to select the video device which will be activated during POST. This
has no effect if external graphics present.
The optional settings are: [VBIOS default]; [CRT+HDMI]; [CRT+LVDS];
[HDMI+LVDS]; [CRT Only]; [HDMI Only]; [LVDS Only].
When user set it as [CRT+LVDS]; [HDMI+LVDS]; or [LVDS Only]. the following
items will show up for user to make further settings:
LCD Panel Type
Use this item to select LCD panel used by Internal Graphics Device by selecting
the appropriate setup item.
Panel Color Depth
Use this item to select the LFP Panel Color Depth.
The optional settings are: [18 Bit]; [24 Bit].
To Next Page
Loading...
Need help?
General
