Intel Express 10 User Manual

36
CHAPTER 3 Intel Express 10/100 Fast Ethernet Switch
get-svlan-tbl {run|nvram}
Displays the SVLAN table.
set-mon-port <port>
Sets the monitoring port.
monitor <port>
Starts port monitoring.
stop-mon
Stops port monitoring.
get-lt-filter <mac_address>
Displays the filter for a given MAC address.
get-con-matrix
Displays the VLAN connectivity matrix.
get-vbc-matrix
Displays the VBC connectivity matrix.
Spanning Tree Commands
get-stp
Displays the spanning tree session state.
set-stp {enable|disable}
Enables or disables the spanning tree for the next session.
get-st-bcfg
Displays the spanning tree bridge parameters.
get-st-pcfg
Displays the spanning tree port parameters table.
get-st-syscfg
Displays the spanning tree system ports configuration.
set-br-prio <priority>
Sets the spanning tree bridge priority.
set-br-maxage <maxage>
Sets the spanning tree bridge maximum age.
set-br-hellot <hello_time>
Sets the spanning tree bridge hello time.
set-br-fwdel <forward_delay>
Sets the spanning tree bridge forward delay.
set-prt-prio <port_number> <port_priority>
Sets the spanning tree port priority.
set-prt-enb <port_number> {enable|disable}
Enables or disables the spanning tree port.
set-prt-pcost <port_number> <path_cost>
Sets the spanning tree port path cost.

Intel Express 10 Specifications

General

Brand	Intel
Model	Express 10
Category	Network Router
Language	English