Intel Server Board STL2 Quick Start Guide 3
Items Provided on the Bootable CD-ROM
Intel Server Board STL2 Product Guide
Intel
®
SC5000 Server Chassis Subassembly Product Guide
Software drivers and utilities
To view the product guides, boot to Windows
†
95/Windows NT
†
/
Windows 98 / Windows 2000 and use Adobe
†
Acrobat
†
.
Safety and Regulatory Compliance
See the Intel Server Board STL2 Product Guide for product Safety and EMC
regulatory compliance information.
Intended uses: This product was evaluated for use in servers that will be
installed in offices, computer rooms, and similar locations. Other uses require
further evaluation.
EMC testing: Before computer integration, make sure that the chassis, power
supply, and other modules have passed EMC testing using a server board with a
microprocessor from the same family (or higher) and operating at the same (or
higher) speed as the microprocessor used on this server board.
Server board diagram label provided: Place the label inside the chassis in an
easy-to-see location, preferably oriented similarly to the server board.
I/O panel label provided: Place the label on the I/O shield. The cut outs are for
the top serial port and the parallel port.
Minimum Hardware Requirements
To avoid integration difficulties and possible board damage, your system must
meet the following minimum requirements. For a list of qualified memory and
chassis components see
http://support.intel.com/support/motherboards/server/STL2/compat.htm
Processor
Minimum of one Intel
®
Pentium
®
III processor and a processor terminator.
Memory
Minimum of 64 MB of 133 MHz, 3.3 V, ECC, PC/133 compliant registered
SDRAM on 168 pin gold DIMMs.
Power Supply
Minimum of 300 W with 0.8 A +5 V standby current (in order to support
Wake On LAN
†
(WOL)). You must provide standby current, or the board will
not boot.
To Next Page
Loading...
Need help?
General
