Intel Server Board STL2 Quick Start Guide 9
Configuration Jumper (1L4)
Jumper Name Pins What it does at system reset
FRB 3 1-2 If these pins are jumpered, FRB is disabled.
Front Cover Chassis
Intrusion Sensor
3-4 This is an alternate connector for the chassis
intrusion switch. The preferred connector is
pins 1-2 on block 6A.
Reserved 5-6 Reserved. These pins should be jumpered
for normal operation.
Reserved 7-8 Reserved. These pins should not be
jumpered for normal operation.
Reserved 9-10 Reserved. These pins should not be
jumpered for normal operation.
Reserved 11-12 Reserved. These pins should not be
jumpered for normal operation.
NOTE: Pins 9-11 should be jumpered for
normal operation.
To Next Page
Loading...
