- 13 -
Use numeric key to enter desired and if necessary press to clear.
Press key, the active low count limit will be shown
Use numeric key to enter desired and if necessary press to clear.
Press key to return weighing mode.
For check limits, just one limit value can set
If both values are deleted, the check mode is deactivated.
The beep sound will be worked as described in the beep parameter
f1 off , beep
PLU (Product Look Up)
PLU are used to store items. It can store up to 99 PLU numbers.
These data should be entered against a particular PLU before the weighing process
starts, so that the desired PLU’s can be recalled during the weighing process. The
data can be stored and recalled manually or by sending data over RS-232 Interface
Storing PLU
Press key to ensure display zero.
Tare and unit weight to be stored can be either taken from a weighing in process or
by enter manually.
Press display will be shown
Press numeric key 2 and 7
Press
Currently stored text will appear
The first digit is flashing, it can
Change by using numeric keys
If necessary, delete additional text
To Next Page
Loading...
