- 5 -
2. INSTALLATION
Unpacking
Carefully take the balance out of its package, make it sure its not damaged and all
accessories are included.
Accessories,
1. Balance
2. Adaptor
3. Stainless steel pan
4. Product manual
Keep the packaging material for your future use.
SETTINGS
Local Scale:
Place the scale on a table.
Place the platform in the locating holes on the top cover.
Do not press with excessive force as this could damage the load cell inside.
Check the water mark. If, bubble is not centre adjust the leveling feet until reach
centre. Check the level when you change the location.
Attach the power supply cable to the connector on the right side of the scale
base. Plug in the power supply module.
Turn on the Scale. The power switch is located at the right side of the scale base.
To Next Page
Loading...
