19
5. In the ‘IP address’ field, fill in any IP address that begins with ‘192.168.1’, and
ends with a value greater than 2 and less than 254, for example 192.168.1.100.
In the Subnet mask field, enter‘255.255.255.0’. Please keep all other fields
empty, and click ‘OK’.
If you change the IP address of this IP camera and you forget it, there’re two ways
you can recover it:
a. Press and hold the ‘Reset’ button located at the bottom of this IP camera
to clear all settings of the IP camera and reset the IP address back to
192.168.1.221. You’ll lose all settings in the IP camera.
b. Ask your network administrator to check the DHCP release table, if the
camera was set to obtain the IP address by DHCP. A new record will be
added to the DHCP release table on the DHCP server when the IP
camera is connected to the local area network.
To Next Page
Loading...
Need help?
General
