1 | Programmer’s Guide IntelliTech International, Inc.
Thermal Printer Programmer’s Guide 30
ERRORBUZZER Used to select the buzzer sound
for an error
DISABLE, SOUND1,
SOUND2
DISABLE
WARNINGBUZZER Used to select the buzzer sound
for a warning
DISABLE, SOUND1,
SOUND2
DISABLE
PRINTSPEED
6,
7, 9
Sets the print speed of the
printer
20 – 80 (1/10 IPS) 60
FEEDSPEED
9
Sets the feed speed of the
printer
0 – 120 (1/10 IPS) 0 (auto)
REVERSESPEED
9
Sets the speed at which the
label will be retracted into the
printer
0 – 50 (1/10 IPS) 0 (auto)
RETRACTTIMEOUT The length of time before the
presented label is retracted to
the next top of label
0 – 1000 (sec) 0
RETRACTDELAY The length of time before the
label is retracted at the next top
of label after
the label has been
removed
10 – 1000 (ms) 70
LABELPRESENTDIST The distance, beyond the
bottom edge of the label, that
the label will be presented to the
user for removal. This is
measured in decipoints.
0 - 2880 0 (auto)
PAPERLOWWARNING Show paper low warning OFF, ON OFF
PAPEROUTWARNING Show paper out warning OFF, ON ON
COVEROPENWARNING Show cover open warning OFF, ON ON
AUTOLOAD Sensors will trigger the
automatic load process when
paper is detected
OFF, ON ON
AUTOOPTIONDETECT Controls the hardware
automatic detection
OFF, ON ON
AUTOCALIBRATE Automatically calibrates the
paper out sensors after loading
the paper
OFF, ON ON
AUTOPRESENTDIST Enables the automatic setting of
the present distance
OFF, ON ON
AUTOTENSION
6
Enables the automatic setting of
tension
OFF, ON ON
AUTOPRESSURE
6
Enables the automatic setting of
pressure
OFF, ON ON
AUTOMEDIAGLOBAL
6
Enables the automatic setting of
media parameters
OFF, ON ON
PAPERLENGTH
7
Sets the print length of the label
in decipoints (1/720th of an inch)
72 - 71280 (1/720") 2880
PAPERWIDTH
7, 8
Sets the print width of the label
in decipoints (1/720th of an inch)
72 - 3074 (1/720") 2880
Variable Description Range Default
To Next Page
Loading...
Need help?
General