IntelliTech International, Inc. Programmer’s Guide | 1
31 Thermal Printer Programmer’s Guide
HORIZONTALOFFSET
7
Shifts the print area of the
logical page to the left or right on
the physical page in decipoints
0 - 7200 0
VERTICALOFFSET
7
Shifts the print area of the
logical page up or down on the
physical page in decipoints
0 - 2880 0
ORIENTATION
7
Controls the orientation of the
logical page on the physical
page
PORTRAIT, LANDSCAPE,
RPORTRAIT,
RLANDSCAPE
PORTRAIT
RASTERMODE
7
This controls how overlapping
images are placed on the paper
TRANSPARENT,
OPAQUE
TRANSPAREN
T
FONTNUMBER
1
This is the typeface number the
printer uses if none is specified
in the command stream
0 – 512 23
PITCH
1
This specifies the default
character pitch in characters per
inch. The default font must be a
fixed pitch font.
0.44 - 99.99 10.00
PTSIZE
1
This specifies the default point
size of the default font. The
default font must be scalable for
this to be effective.
4.00 - 999.75 12.00
SYMSET
1
This specifies the default
symbol set. The symbol set
must be resident in the printer.
PJL sym set name3 PC8
PRINTTRUNCATION
7
This clips the print image at the
MARK or GAP. If the
PAPERTOFTYPE is "NONE"
then clip at PAPERLENGTH.
OFF, ON ON
PRINTONGAP Sets the printer to print on gap/
mark or not
OFF, ON OFF
DARKNESS
7
This allows for the adjustment of
the darkness of the printed
image due to printhead thermal
variations.
± 20 0
SHARPNESS
4, 7
This allows for the adjustment of
the leading edge darkness of
the printed image due to
printhead thermal variations.
± 10 0
VERTICALADJ
4
This allows for the vertical
adjustment of the start of image
relative to the horizontal leading
label edge due to mechanical
variations.
± 100 0
HORIZONTALADJ
4
This allows for the horizontal
adjustment of the image relative
to the printhead center.
± 100 0
Variable Description Range Default
To Next Page
Loading...
Need help?
General