BSC4 Operating Manual
Interface Inc. ● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com ● Email: contact@interfaceforce.com ● 800.947.5598
Document Number 15-183 Rev B Page 58 of 74
4.5.8. Noise suppression
A. Noise-cut enabled – If measuring values are between Noise-cut threshold and (Noise-cut
threshold), they will be set to 0.000000000, so that the noise around zero will be
suppressed. Set checkbox to enable this feature.
B. Input Channel = 0: Apply all channels – Input channel to be used with Noise-cut. Set to
0: Use the same threshold for all inputs.
C. Noise-cut threshold – If measuring values are between Noise-cut threshold and (Noise-
cut threshold), they will be set to 0.000000000, so that the noise around zero will be
suppressed.
FIGURE 73 - NOISE SUPPRESSION
4.5.9. Auto-Zero enabled – Every (Time interval) seconds, an automatic set-zero routine will be
performed.
FIGURE 74 - AUTO-ZERO
To Next Page
Loading...