Chapter 4: Operating instructions
16 TruVision NVR 10 User Manual
Figure 4: Front panel
Table 2: Front panel elements
. Live view button Switch to live view mode.
. Playback buttons See Table 3 on page 17 for a detailed description of all these
buttons for different tasks.
Reverse: In live view mode, use to play back the earliest
video. In playback mode, playback a camera in the reverse
direction.
Pause: In live view, freeze the last image of the l
all active cameras displayed. In playback mode, stop playback.
Play: In live view mode, play all-day playback of the current
camera (upper-left video tile if in multiview mode). In playback
mode, play back a camera in the forward direct
play back a selected video or view a snapshot.
. IR receiver Receiver for IR remote.
To connect the remote control to the NVR, press the Device button,
enter the device address, and press Enter. See āUsing the IR
remote controlā on page 19 for more information.
. Direction The DIRECTION buttons are used to navigate between different
fields and items in menus.
Enter button The ENTER button is used to confirm selection in any of the menu
modes.
See Table 3 on page 17 for a detailed description of these buttons
by different tasks.
. Alarm button Use to manually acknowledge an alarm.
. USB Interfaces Universal Serial Bus (USB) ports for additional devices such as a
USB mouse, CD/DVD burner, and USB Hard Disk Drive (HDD).
. Archive button Press once to enter quick archive mode. Press twice to start
archiving. If the flash drive has an LED, it will flash during archiving.
. Display buttons See Table 3 on page 17 for a detailed description of all these
buttons for different tasks.
Display: In multiview mode, toggle through the various multiviews
(full, quad, 1+5, 1+7, 9, and 16).
In HDD information mode and user management mode delete a
To Next Page
Loading...
