20 TruVision Series 3 IP Camera FW3.1 Configuration Manual
To define the SNMP parameters:
1. Click Configuration > Network > SNMP.
2. Select the corresponding version of SNMP: v1, v2c, v3, or “Other Settings”.
3. Configure the SNMP settings. The configuration of the SNMP software should
be the same as the settings you configure here.
4. Click Save to save changes.
Note: Before setting the SNMP, please download the SNMP software and
ensure that you can receive the camera information via the SNMP port. By
setting the Trap Address, the camera can send the alarm event and exception
messages to the surveillance center. The SNMP version you select should be the
same as that of the SNMP software.
To Next Page
Loading...
