Chapter 3 — Configuring the CK32 I-Safe
42 CK32 I-Safe Handheld Computer User’s Manual
To use the CK32 I-Safe in an Ethernet network
1 Tap the iConnect icon ( ) in the lower right corner of the
Today screen.From the menu, select Enable > Ethernet. This
change disables 802.11 networking on the CK32 I-Safe.
2 You will be prompted to reboot the device for changes to take
affect. Press and hold the Power button for 10 seconds to
initiate the reboot. Do not use the Reset button. See
“Preferred Reset Method” on page 114 for more information.
3 Go to Start > Settings > the System tab > Intermec Settings
> Communications > Ethernet Adapter > IP Settings.
4 If you have a DHCP server, enable DHCP.
or
If you do not have a DHCP server, set these parameters:
• IP address
•Subnet mask
• Default router
Intrinsically Safe rules prohibit direct connection to the CK32
I-Safe.
To Next Page
Loading...
