Intermec EasyCoder 3400e Quick Start Guide

8 EasyLAN Wireless Quick Start Guide
To use WPA-Personal, you need:
• an access point that supports WPA-Personal (PSK). You can
use an Intermec MobileLAN access point with software v1.80
or later. For help, see the access point system manual.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.
To use WPA-Enterprise, you need:
• an authentication server. You can use a PC with the Funk
Odyssey
TM
RADIUS server software v1.1 or later. You can use
an Intermec MobileLAN
TM
access point with software v1.80
or later; for help, see the access point system manual. Or, you
can use a compatible authentication server.
• an authenticator that supports TTLS, such as an Intermec
MobileLAN access point with an 802.11b radio and software
v1.80 or later. The authenticator knows the IP address and
secret key of the authentication server and translates TTLS
frames to Remote Authentication Dial-In User Service
(RADIUS) frames and vice versa.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.

Intermec EasyCoder 3400e Specifications

Cutting Specifications

rating for 0.005-inch paper	1, 000, 000 cuts
rating for 0.010-inch paper	500, 000 cuts
cutting method	Guillotine-type blade

Dimensions and Mounting

adds to printer length	0.5 inch
minimum media width	0.75 inch
maximum media width	4.5 inches

Media Specifications

maximum media thickness	0.010 inch
minimum liner weight	40 lb
minimum cut length	1.0 inch