EasyLAN Wireless Quick Start Guide 7
System Requirements
To set up printing through EasyLAN Wireless, you need to
know if you have an ad-hoc or infrastructure network:
• In an ad-hoc network, you need a PC with an 802.11b card
or other 802.11b device that can print straight to the printer.
• In an infrastructure network, you need an installed 802.11b
network that allows devices to print to the printer.
To use 802.1x security and TTLS, you need:
• an authentication server. You can use a PC with the Funk
Odyssey
TM
RADIUS server software v1.1 or later. You can use
an Intermec MobileLAN
TM
access point with software v1.80
or later; for help, see the access point system manual. Or, you
can use a compatible authentication server.
• an authenticator that supports TTLS, such as an Intermec
MobileLAN access point with an 802.11b radio and software
v1.80 or later. The authenticator knows the IP address and
secret key of the authentication server and translates TTLS
frames to Remote Authentication Dial-In User Service
(RADIUS) frames and vice versa.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.
To use 802.1x security and LEAP, you need:
• an authentication server. You can use a PC with the Funk
Odyssey RADIUS server software v1.1 or later. You can use
an Intermec MobileLAN access point with software v1.80 or
later. For help, see the access point system manual.
• an authenticator that supports LEAP, such as a Cisco 1200
series or Cisco 350 series access point with an 802.11b radio.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.
To Next Page
Loading...
Need help?
Cutting Specifications
