Intermec EasyCoder PX6i Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 13
2
Physical Installation
 is chapter describes how to physically install the
EasyLAN Wireless interface kit in a PF2/4i-, PM4i-,
or PX4/6i-series printer.
 e installation described in this chapter
must only be performed by an authorized
service technician. Intermec assumes
no responsibility for personal injury or
damage to the equipment if the instal-
lation in performed by an unauthorized
person.
Take precautions against electrostatic
discharges, for example by wearing
grounded bracelets.
Note: When the EasyLAN Wireless
interface is factory-installed in a printer,
the antenna is packed separately in the box
and must be fi tted to its connector on the
printer’s rear plate as illustrated at the end
of this chapter.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g