EasyLAN Wireless Interface Kit Installation Instructions 27
4
Setup in Fingerprint
is chapter explains how to set up the wireless net-
work communication in printers running Intermec
Fingerprint v8.40 (or later). e only requirement
on the PC side is a terminal program that can trans-
mit and receive ASCII characters on an RS-232 line.
us, this method is recommended when you do not
have the opportunity to run the Intermec EasyLAN
Network Setup wizard, for example because you use
an operating system other than Windows.
For information on how to set up the network com-
munication in printers running IPL, refer to
Chapter 5.