Intermec EasyCoder PX6i Installation Instructions

54 EasyLAN Wireless Interface Kit Installation Instructions
Chapter 5 — Setup in IPL
 e following regulatory domains are implemented:
Value Countries Allowed channels
FCC (or USA) U.S.A 1-11 (default)
IC (or Canada) Canada 1-11
ETSI (or EU) EU countries
1
+ Iceland,
Liechtenstein, Norway, and
Switzerland
1-13
MKK (or Japan) Japan 1-14
1
/. Certain restrictions apply to outdoor use in France.
<STX><SI>wt,.REGION<ETX>
Transmits the active region.
Finishing the Wireless Setup
You can now disconnect the printer from the PC. You still need to assign
an IP address, subnet mask, default router, and name server.  is can be
done via the printer’s display and keyboard (provided the server supports
DHCP or BOOTP). If not, you must rely on wireless communication
and use the ARP’n’PING method, which require that there is a work-
ing wireless LAN and the printer is inside the coverage area of an access
point.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g