EasyManua.ls Logo

Intermec EasyCoder PX6i - Page 57

Intermec EasyCoder PX6i
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EasyLAN Wireless Interface Kit Installation Instructions 53
Chapter 5 — Setup in IPL
Signal Strength
An important tool when working out problems with wireless LANs
is a signal strength meter.  e printer monitors the received signal
strength, and makes it available to the user.  e read-only setup variable
“SIGNAL” assumes the value of the current received signal strength.  e
value may vary from 0 (no signal) to 100 (maximum strength).
<STX><SI>wt,SIGNAL<ETX>
Transmits signal strength.
Speed
Depending on diff erent (radio) network parameters—such as distribu-
tion of access points, frequencies, number of clients, etc.—the network
card may select a lower speed than the maximum for better overall per-
formance.  e selected speed (rounded down to whole Mbps) can be
read from the printer.  e read-only setup-variable “SPEED” can assume
values from 0 up to 54 (Mbps).
<STX><SI>wt,SPEED<ETX>
Transmits network speed.
Region (a.k.a. Regulatory Domain)
Some countries and regulatory authorities only allow the use of a subset
of the 14 channels specifi ed in the 802.11b/g standard. To make the
product world confi gurable the setup variable “.REGION” is used.
e region can only be set by personnel authorized by Intermec. If the
wrong region/domain is set, please contact your Intermec representative
immediately. Continued use of the EasyLAN Wireless network interface
with an incorrect REGION setting may be in violation of applicable
laws.
e region setting will not be reset to default, even if a factory default
upgrade is performed.

Other manuals for Intermec EasyCoder PX6i

Related product manuals