Intermec EasyCoder PX6i Installation Instructions

EasyLAN Wireless Interface Kit Installation Instructions 39
Chapter 4 — Setup in Fingerprint
Region (a.k.a. Regulatory Domain)
Some countries and regulatory authorities only allow the use of a subset
of the 14 channels specifi ed in the 802.11b/g standard. To make the
product world confi gurable the setup variable “.REGION” is used.
 e region can only be set by personnel authorized by Intermec. If the
wrong region/domain is set, please contact your Intermec representative
immediately. Continued use of the EasyLAN Wireless network interface
with an incorrect REGION setting may be in violation of applicable
laws.
 e region setting will not be reset to default, even if a factory default
upgrade is performed.
 e following regulatory domains are implemented:
Value Countries Allowed channels
FCC (or USA) U.S.A 1-11 (default)
IC (or Canada) Canada 1-11
ETSI (or EU) EU countries
1
+ Iceland,
Liechtenstein, Norway, and
Switzerland
1-13
MKK (or Japan) Japan 1-14
1
/. Certain restrictions apply to outdoor use in France.
SETUP GET "wlan",".REGION",A$
Gets the active region in A$.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g