Intermec PB21 User Manual

Chapter 2 — Configuring the PB21 and PB31
PB21 and PB31 Mobile Receipt Printer User Guide 35
3 From the host PC, check the wireless settings.
If you have an IPL version of the printer, send these commands to
the printer:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, send this
command to the printer:
setup write "wlan","uart1:"
4 Set up the printer to use the correct SSID and authentication
modes. See one of these procedures to configure wireless printing
on your IPL or Fingerprint printer.
5 If you are going to use certificates for validation, transfer the
certificate to the printer. The printer can accept .pfx, .pem, and
.der certificates.
6 Verify that the printer is connected to the access point and make
sure it has an IP address allocated to it.

Intermec PB21 Specifications

General

Brand	Intermec
Model	PB21
Category	Printer
Language	English