PB3 Mobile Printer User’s Guide 23
1 Print a configuration test page. For help, see “Printing a
Configuration Test Page” on page 11.
2 Configure the printer for a serial connection and connect it to the
host computer with a serial cable. For help, see “Setting Up Serial
Communications” on page 14.
3 Open Tera Term. The printer turns on when the program connects
to the printer.
4 As soon as you see the text
bootloader v1.xx, press Backspace.
This message appears:
Erase user code?
5 Press Y. This message appears:
Erasing...
Erased Internal Bank 0.
Erased External Flash Chip.
Send a Hex File.
6 Send the firmware file to the printer. The printer loads the new
firmware, which takes 4 to 5 minutes. When the firmware is
loaded, the printer responds with
Done.
7 Start the Tera Term application.
8 From the Setup menu, select Serial port.
9 Configure the serial port settings as shown:
10 Click OK.
Note: If the printer does not turn on, you need to cycle power to
the printer. Remove and install the battery, or unplug and connect
the AC power connector.
To Next Page
Loading...
Need help?
General
