Chapter 1 — Using the PB22 and PB32 Mobile Label and Receipt Printer
PB22 and PB32 Mobile Label and Receipt Printer User Guide 11
Using the Batteries
The printer uses a rechargeable 7.4 V 2300 mAh lithium-ion battery
(Model AB27) for power. You must fully charge the battery before you
can use the printer. The battery retains a charge for up to five days
when the printer is in Standby mode.
A fully charged battery can usually print over 300 6-inch labels (PB32)
or 500 6-inch labels (PB22) at 25% print density. When the printer
reports low battery, it can usually print over 50 6-inch labels at 10%
print density. The number of labels you can print varies depending on
these factors:
• Age of the battery
• Temperature and humidity of the operating environment
• Printer configuration, including network connection settings
• Type of media loaded in the printer
• Amount of data printed for each label
• Threshold at which you configure the low battery warning
Use Intermec Model AB27 battery only. Use of another battery
may present a risk of fire or explosion.
The Model AB27 battery may present a fire or chemical burn
hazard if mistreated. Do not disassemble, heat above 100 °C
(212 °F), or incinerate. Dispose of used batteries promptly. Keep
away from children.
To Next Page
Loading...
Need help?
General
