Chapter 2 — Configuring the PB22 and PB32
PB22 and PB32 Mobile Label and Receipt Printer User Guide 35
Setting Up 802.11 Radio Communications
The printer can have an internal 802.11 b/g radio to transfer and
receive data using wireless communications. This manual assumes
that you have already set up your wireless communications network
including your access points. These procedures include information
about setting up wireless security for both IPL and Fingerprint
versions of the printer.
The printer supports these authentication modes: none, WEP, WPA
Personal and Enterprise mode (802.1x authentication), WPA2
Personal and Enterprise mode (802.1x authentication).
To set up the printer to work in your wireless network, you need:
• Serial cable (P/N 075497-xxx).
• Host PC running Windows or Linux.
• Active 802.11b or 802.11g wireless access point.
• Communications application, such as PrintSet or HyperTerminal.
To set up the printer for wireless communications using PrintSet
1 Connect the 8-pin circular DIN connector to the serial port on the
printer. Connect the other end of the serial cable to a serial port on
your PC.
2 On your PC, start PrintSet.
3 Select your printer from the My Printers list. For more
information on how to add a printer to PrintSet, see “To connect
the printer to a PC through the serial port using PrintSet” on
page 31.
Note: WPA and WPA2 Enterprise modes currently support PEAP,
TTLS, and LEAP. For LEAP authentication, the printer supports
Open EAP, but does not support Network EAP.
Note: If you are using IPL commands with HyperTerminal, you may
want to be able to see the commands as you type them on your
screen. For help, see “Changing Configuration Settings Using the
Command Line” on page 44.
To Next Page
Loading...
Need help?
General
