Appendix A — Specifications
70 PB22 and PB32 Mobile Label and Receipt Printer User Guide
When you order printer media, keep these points in mind:
• Gap, notch, and black marks are used as repeat indicators:
• Gap: Label and fanfold media
• Notch: Tag media
• Black mark: Tag and fanfold media. Black marks are sensed on
the side of the media that is thermally sensitive.
• You can use higher caliper media in the printer, but print quality
will be reduced.
• Receipt roll stock media is supplied as a continuous roll and has
an end of roll indicator. The end of roll indicator is a red marking
(on last 3 feet of roll) on the side of the paper that is thermally
sensitive.
Specialty media is required for unique customer environments,
including printer operating temperature extremes. Intermec
recommends that you test the media in your application.
Supported Media
The printer supports direct thermal label, tag, and receipt media.
Both North American and European label media are supported in
multiple label lengths. Receipt media is supported in both a top
coated and an uncoated paper in continuous roll stock only.
External Fanfold Media Specifications
Stack height: 70 mm (2.75 in)
Page length: 152 mm (6 in) to 305 mm (12 in)
Note: A 6-inch page length is supplied in 12-inch long stacks (two
6-inch stacks of equal height with the bottom page linked).
Note: To configure the printer for coated media (floodcoated media),
see “Printing on Floodcoated Media” on page 19.
To Next Page
Loading...
