EasyManua.ls Logo

Intertek MBU 400 - Frame Repetition Stability

Default Icon
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTERTEK TESTING SERVICES
Test Report Number: HK08060834-1 Page 40 of 72
FCC ID: T7HCT8015
Company: RTX Consumer Products Hong Kong Ltd. Date of Test: June 24-July 7, 2008
Model: MBU 400
4.14 Frame Repetition Stability, FCC Rule 15.323(e):
[ × ]
EUT implements Time Division Duplex (TDD) in order to support duplex
connection on a given frequency carrier shall maintain a frame repetition rate
whereby 3 X the standard deviation of the frequency stability shall not exceed
50 ppm, not including a shift of the mean.
[ × ]
EUT uses Time Division Multiple Access (TDMA) in order to support multiple
communication links on a given frequency carrier shall maintain a frame
repetition rate whereby 3 X standard deviation of the frequency stability shall
not exceed 10 ppm, not including a shift of the mean.
Measurements are made in accordance with ANSI C63.17 sub-clause 6.2.2. Test setup is
shown in section 3.2 Figure 3.2.1. A spectrum analyzer measures the time duration
between rising edges of two consecutive frames over a time period of at least 1000 frame
periods. These measurement values are used to compute the 3 X standard deviation of
the frequency stability.
Test Results:
Maximum Frame Repetition Stability
(ppm)
Limit (ppm) Results
<0.0001 10 Pass

Table of Contents