EasyManua.ls Logo

Intertek MBU 400 - Automatic Discontinuation of Transmission

Default Icon
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTERTEK TESTING SERVICES
Test Report Number: HK08060834-1 Page 23 of 72
FCC ID: T7HCT8015
Company: RTX Consumer Products Hong Kong Ltd. Date of Test: June 24-July 7, 2008
Model: MBU 400
4.7 Automatic Discontinuation of Transmission, FCC Rule 15.319(f):
The EUT shall automatically discontinue transmission in case of either absence of
information to transmit or operational failure. These provisions are not intended to
preclude transmission of control and signaling information or use of repetitive codes used
by certain digital technologies to complete frame or burst intervals.
Test Procedures:
The following tests simulate the reaction of EUT in case of either absence of information
to transmit or operational failure after a connection of its companion device is established.
Test setup is shown in section 3.2 Figure 3.2.1.
Test Descriptions and Results:
Test Descriptions Reaction of EUT Results
1 Switch-off companion device NA NA
2 On Hook by companion device B Pass
3 Remove power from companion device B Pass
4 Switch-off EUT NA NA
5 On Hook on EUT Side NA NA
6 Remove power from EUT A Pass
7 Reset EUT B Pass
A Connection is terminated and, transmission ceases.
B –
Connection is terminated but EUT transmits control or signaling
information.
C –
Connection is terminated but companion device transmits control or
signaling information.
NA –
Not applicable, represents the device does not contain a hook switch or a
power off switch
[ × ]
The manufacturer declares that the EUT can automatically discontinue
transmission in case of either absent information to transmit or operational
failure. The manufacturer’s declaration is saved as filename: declaration.pdf

Table of Contents