261
PO
(261PO) Sand Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 07/23/2014
English
SAVE THESE INSTRUCTIONS
Page 15
Initial startup and operation:
Before operating, be sure that:
• Allthehoseshavebeenconnectedandtightenedsecurely,andcorrectamountoffiltersand
have been loaded.
• Theentiresystemisconnectedtoagroundingtypereceptacleprotectedbyaground-fault
circuitinterrupter(GFCI)orresidualcurrentdevice(RCD).
OPERATING INSTRUCTIONS (continued)
CAUTION
The filter control valve has a closed position. The pump should never be on when
the valve is in the closed position. If the pump is operated with the valve closed, and
explosive situation could exist.
1.
Turn both plunger valve handles fully counter-clockwise until they stop. This opens the valves
to allow water to flow into the sand filter pump.
2.
Ensure the drain/waste outlet on the 6-way valve is not covered and directed to a proper
draining receptacle.
3.
Ensure the pump is off, depress the 6-way valve and turn it
to the “
BACKWASH
” position
(see drawings 27 & 32)
.
IMPORTANT: To prevent damage to the 6-way valve,
always depress the valve handle before turning. Always
switch off pump before changing the 6-way valve
position.
4.
Switch on the pump
(see drawing 33)
. Water is circulating
backward through the sand media and to waste/drain outlet.
Backwashuntilaclearflowofwaterisobservedinthe
waste/drain outlet or through the drain sediment window.
NOTE:
The initial backwash of the filter is recommended to
remove any impurities or fine sand particles in the sand
media.
32
1
2
33
OFF
ON
To Next Page
Loading...
Need help?
General
