EasyManuals Logo

Intex ECO 20110 User Manual

Intex ECO 20110
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
261
PO
(261PO) Sand Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 07/23/2014
English
SAVE THESE INSTRUCTIONS
Page 33
COMMON POOL PROBLEMS
PROBLEM DESCRIPTION CAUSE SOLUTION
ALGAE
FLOATING
MATTERIN
WATER
CHRONIC
LOW WATER
LEVEL
SEDIMENT
ONPOOL
BOTTOM
SURFACE
DEBRIS
•ChlorineandpHlevels
need adjustment.
•"Hardwater"caused
byatoohighpHlevel.
•Chlorinecontentislow.
•Foreignmatterin
water.
•Riporholeinpool
liner or hoses.
•Thedrainvalvesare
loose.
•Heavyuse,gettingin
and out of pool.
•Pooltoocloseto
trees.
• Superchlorinatewithshock
treatment.CorrectpHtoyour
poolstore'srecommended
level.
• Vacuumpoolbottom.
• Maintainproperchlorine
level.
• CorrectthepHlevel.Check
with your pool dealer for
advice.
• Adjustthechlorinelevel.
• Repairwithapatchkit.
• Fingertightenallcaps.
• UseIntexpoolvacuumto
clean bottom of pool.
• UseIntexpoolskimmer.
•Greenishwater.
•Greenorblack
spots on pool liner.
•Poollineris
slippery and/or has
a bad odor.
•Wateriscloudyor
milky.
•Levelislowerthan
on previous day.
•Dirtorsandon
pool floor.
•Leaves,insects
etc.
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department
for assistance. See separate “Authorized Service Centers” sheet.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex ECO 20110 and is the answer not in the manual?

Intex ECO 20110 Specifications

General IconGeneral
BrandIntex
ModelECO 20110
CategoryWater Pump
LanguageEnglish

Related product manuals