Intex ECO 20110 User Manual

261
PO
(261PO) Sand Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 07/23/2014
English
SAVE THESE INSTRUCTIONS
Page 18
SALTWATER SYSTEM OPERATION (continued)
5
.
Boost cycle
•
Firsttimeinstallation,pressandhold“BOOST”
button for 5 seconds until the indicator lights up and the
LED display “80”. This indicates that the saltwater
system has started E.C.O. and more chlorine sanitizer
 production.Youcanpressandholdthe“BOOST”buttonfor
another 5 seconds until the indicator is off, which will cancel the
 Boostcycle.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if your
saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours. After
boost procedure has been completed, the system will automatically switch to the normal
working mode.
•
Afteraheavyrainorifthepoolisdirty,pressthe“BOOST”buttontoshockthepoolagain.
6. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the control panel
 lightsupandtheLEDdisplayflashes“93”.ThesystemisnowinStand-By
mode. After a while, it shuts down and sets itself in a Power Saving mode.
The system will automatically turn itself back on in 24 hours, starting its
daily cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the Power Saving
mode. The LED display however, goes blank after 5 minutes. Press any
button ( or ) to view the last LED code.
7. Running the pump alone without the Saltwater System:
To run the pump alone without the Saltwater System function, press and
hold both ( ) and ( ) buttons for 5 seconds until you hear a “beep” and
 theLEDdisplayshows“FP”.Thepumpisnowoperatingalone.Tostopthe
 pump,manuallyturntheswitchOFF.
NOTE:
The pump cannot be operated
alone under an automatic timer mode.
To bring back the initial automatic operating cycle setting of the
Saltwater System:
 a) IftheLEDdisplayshows“FP”,pressthebuttonandtheoperating
hours set previously will begin flashing, press the button again or
simply wait 1 minute, and the LED will stay illuminated. The Saltwater
System cycle repeats again.
 b) IftheunitisOFF,turntheswitchON,theLEDdisplayshows“FP”,
press the button and the operating hours set previously will begin
flashing, press the button again or simply wait 1 minute, and the
LED will stay illuminated. The Saltwater System cycle repeats again.

Intex ECO 20110 Specifications

General

Brand	Intex
Model	ECO 20110
Category	Water Pump
Language	English