To
view
the
TIMER
preset hours:
While the pump is operating,
press@button,
the display will briefly flash the preset hours for
10
seconds and then display back the remaining operating hours.
To
operate the
sand
filter
pump
manually (without
the
"TIMER"
mode):
1. To run the pump alone without the "Timer",
press@button
to turn
on
the pump, then
press@
button until the LED displays "FP",
.....
this indicates that the TIMER
is
off and the pump is now operating
continuously.
2. To stop the pump,
press@button
again.
Set
operating
hours
for
the
Chlorinator:
1.
Press@
button to unlock the keypad.
With LED flashing, press
@)
button to
01.0••·"""
set the desired operating hours. See the
"Operating Time Table" for the required
operating hours related to each pool size.
!
..!..
Q,
■
ru,Q,,,.
"'"Q'
@Cg)
00'2,
0
-
@@
, -
..,~
!
Ill
~CJ,,,.
..!..
0
...
..,
Q,
@
Cg)
_q,
0
.2
-
~~@~
Pressing @ will increase the time from
"'°""'
T
OR
(0 to 12 ho
ur
s max per cycle)
00 to
12
hours maximum.
If
you have
selected too many hours keep pressing
@ to repeat the cycle. The built-in timer
wi
ll now
01.MNAT
OR
activate your chlorinator,
at
the same time each day, for the number
of
hours you have set.
2. With the desired hour value showing, press @ button to lock the keypad controls. The
chlorinator indicator light is
up
when activated. The system is now starting chlorine sanitizer
production and will stop after the operating hours are completed.
NOTE: If you forget to lock the keypad controls, the system will automatically lock it and start
working 10 seconds later.
3. The system
in
chlorinator mode will activate the pump automatically, the LED will always
first display the remaining chlorinator hours until it's finished. To check the preset chlorinator
hours, you need to unlock the keypad and press
@ button.
QlOA:NATOR
4. To stop the chlorinator, press
'66'
button to unlock the keypad controls, then press @
0
""""'TOR
button and reset the hour to "00".
NOTE: If the chlorinator and the filter pump are
in
timer mode and the chlorinator timer is set
longer than the filter pump timer, the filter pump timer will automatically change to the same
time as the chlorinator set time.
To Next Page
Loading...
Need help?
General
