11
SECTION 3—ARMRESTS
S E C T I O N 3 — A R M R E S T S
W A R N I N G
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur. To adjust
the armrest, refer to dedicated paragraphs in user manual.
Removing/Installing/Adjusting, Removable and Multi-
adjustable Armrest
NOTE: For this procedure, refer to FIGURE 3.1.
NOTE: To remove the multi-adjustable armrest, reverse this procedure.
1. Pull or Push the armrest by the arm cushion out of the armrest holder
C
or
D
.
2. To adjust how easy or difficult it is to pull/push the armrest out of the holder, change
the degree to which the handle
B
is tightened.
Adjusting removable armrest width
1. Loosen the screw
G
(M6) with 5 mm Allen key at bottom of the armrest bracket.
2. Move the armrest sideward until you reach the desired width, while keeping
screw
G
in place.
3. Tighten firmly (8-9 Nm) the screw
G
(M6) with 5 mm Allen key.
4. Perform the setting on both sides, if necessary.
Adjusting the armrest height
1. Loosen the screw
A
(M6) with 5 mm Allen key at bottom of the armrest bracket.
2. Move the armrest upwards or downwards until you reach the desired height,
while keeping screw
A
in place.
3. Tighten firmly (5-6 Nm) the screw
A
(M6) with 5 mm Allen key.
4. Perform the setting on both sides, if necessary.
Adjusting the armrest depth (2 positions)
1. Loosen the screw
G
with 5 mm Allen key of the armrest bracket.
2. Move the armrest holder until in the desired position, frontwards
F
or
backwards
E
(move screw
G
if necessary).
3. Tighten firmly (8-9 Nm) the screw
G
with 5 mm Allen key.
4. Perform the setting on both sides, if necessary.
Adjusting the side protection height
1. Loosen the 2 screws (inside location) of the side protection with 4 mm Allen
key or Pozidriv screwdriver.
To Next Page
Loading...
