SECTION 4—SEAT/BACK
1 9
.
Removing/Installing different type of Backrests
NOTE: For this procedure, refer to FIGURE 4.7, next page
Folding backrest
NOTE: To Install the Fixed/Folding backrest, reverse this procedure from STEP 3 to 1.
1. Remove the back-cane bracket. Refer to Removing Back-cane Bracket paragraph.
2. Pull up on the seat upholstery.
3. Remove the two mounting screws and locknuts (M6) that secure the back-cane
bracket to the wheelchair frame.
4. Install the new set including the appropriate backrest upholstery
NOTE: Both back-cane brackets should be set to the same adjustment holes.
DETAIL « A »
Backrest Adjustable
-15°/+15°
DETAIL « B »
Step Less Adjustment
-15°/+15°
FIGURE 4.6 Adjusting the Angle Adjustable Backrest
Allen Key 5 mm
To Next Page
Loading...
