43
7.11 Installing / Removing Seat Board
WARNING:
This adjustment should only be performed when the wheelchair is unoccupied. Take care not to damage any
accessories fitted to the seat board.
To install/remove the seat board from the
wheelchair seat frame:
1. Remove the seat cushion.
2. Remove the four ‘R’ clips (A) that secure the
seat board to the seat frame.
3. Install / Remove the seat board.
4. Replace ‘R’ clips (A). Ensure the clip is pushed
fully into position.
NOTE:
Ensure the seat board is firmly secured before fitting the cushion or using the wheelchair.
A
To Next Page
Loading...
