INVENTOR ATM10S3 User Manual

7
Matrix Mono
Matrix Mono
6
2 Unit Capacies
Table 1-2.1: Matrix Mono unit capacity range and unit appearances
Capacity 4kW 6kW 8kW 10kW 12kW 14kW 16kW
Model
1
ATM(H)04S(3) ATM(H)06S(3) ATM(H)08S(3) ATM(H)10S(3)
ATM(H)12S(3)/T(9) ATM(H)14S(3)/T(9) ATM(H)16S(3)/T(9)
Appearance
Notes:
1. The presence or omission of the leers S or T in the model names indicates the unit’s power supply:
T: 3
-phase, 380-415V, 50Hz; S: 1-phase, 220-240V, 50Hz.
3 Nomenclature
08
AT
M H S 33
3kW Electric Heater (choices: empty, 3, 9)
S=Single phase
T=Triple phase
8kW (choices: 04,06,08,10,12,14,16,)
With Electric Heater pre-installed
(choices: H or nothing)
M: Monoblock Type (S: Split-Type)
Heat pump
Matrix Mono
7
Part 1 - General Informaon
4 System Design and Unit Selecon
4.1 Selecon Procedure
Step
1: Total heat load calculaon
Calculate condioned surface area
Select the heat emiers (type, quantity, water temperature and heat load)
Step
2: System configuraon
Decide whether to include AHS and set AHS’s switching temperature
Decide whether backup electric heater is enabled or disabled
Step 3: Selecon of outdoor units
Determine required total heat load on outdoor units
Set capacity safety factor
Select power supply
Provi
sionally select Matrix Mono unit capacity based on nominal
capacity
Correct capacity of the outdoor units for the following items:
Outdoor air temperature / Outdoor humidity / Water outlet temperature
1
/
Altude / An-freeze fluid
Is corrected Matrix Mono unit capacity ≥ Required total heat load on
outdoor units
2
Ye
s No
Matrix M
ono system
selecon is complete
Select a larger model or enable
backup electric heater operaon
Notes:
1. If the required water temperatures of the heat emiers are not all the same, the Matrix Mono’s outlet water temperature seng should be set at the
highest of the heat emier required water temperatures. If the water outlet design temperature falls between two temperatures listed in the outdoor
unit's capacity table, calculate the corrected capacity by interpolaon.
2. If the outdoor unit selecon is to be ba
sed on
total heating load and total cooling load, select Mono units which sasfy not only the total heating load
requirements but also the total cooling load requirements.

INVENTOR ATM10S3 Specifications

General

Brand	INVENTOR
Model	ATM10S3
Category	Air Conditioner
Language	English