98
Inventor Matrix Mono Engineering Data Book
Step 11. Select the “KJRH-120F/
BMKO-E”
Step 12. On the wired controller, select “MENU”, then “WLAN SETTING” and
press “OK”. Select “AP mode” and press ok. Click once the right buon to
selecty the “OK” command, and please “OK” to enter the WiFi mode. The WiFi
icon on the wired controller will start ashing. Make sure you complete the
operaon in 90 seconds aer the icon starts ashing. Check the “Operaon
completed on the boom part of the screen of the mobile/tablet, and select
the “Next step” to connue”.
Step 13. Select “Set up WiFi”
to nd and connect to the heat
pump’s WiFi.
Step 14. In your device’s wi
networks, nd the net_xx_xxxx
network and press to connect. The
password is “12345678”.
Step 15. Once connected to the
device’s wi, return to the APP. The
process will automacally proceed.
Allow for a few minutes for the
process to complete.
To Next Page
Loading...
