Invisio V60 - Audio Tones and Glossary; General Audio Tone Rules; Hear-Thru Control Tones; Radio Control Tones

26 27
www.invisio.com
CUP11968-9
© 2017 INVISIO Communications A/S.
INVISIO is a registered trademark of
INVISIO Communications A/S.
BCM
INVISIO Bone Conduction Microphone.
Patented in-ear communication microphone for transmitting.
Hear-Thru
Microphone situated on the headset to monitor audio
situational awareness of ambient surroundings.
PTT
Push-to-talk is used when transmitting during a 2-way radio
communication. Pressing the PTT button enables transmission.
Releasing enables monitoring.
PTT Mode
PTT Mode allows communication in both directions, but not
simultaneously. When receiving the user must wait for the
signal to end, before begin transmitting.
Open Mic Mode
Open-Mic Mode allows communication in both directions
simultaneously. This allows all users to monitor and transmit
at the same time.
Latching
Latching is turning and keeping the microphone on.
INVISIO IntelliCable
™
Intelligent cable system enabling recognition of attached device.
Glossary of TermsAudio Tones
General Rule for Audio Tones
The general rule for the V60 audio tones is based an on/o rule:
• On: 1 Beep
• O: 2 Beeps
• Error: 3 Beeps
Hear-thru control
• Hear-thru on (1 Beep) - Hear-thru o (2 Beeps)
• Volume up/down (1 Beep)
Radio control
• PTT press (1 Beep) - PTT release (2 Beeps)
• Connect radio (No Tone) - Disconnect radio (No Tone)
• Latching on (1 Beep) - Latching o (2 Beeps)
System
• Power on (1 Beep)
• Power O (No Tone)
• Open Mic Mode: On (1 Beep) - O (2 Beeps)
Note
When using a battery pack (PS30), please refer to its user
manual for tones.