Invisio V60 - Single Radio Monitoring and Alternative States; Activating Monitor Single Radio; Monitor Single Radio Key Combo; Monitor Single Radio Tones

16 17
Monitor Single Radio
Note
An error tone is heard when no cable is connected to the
COM port being set to Monitor Single Radio Mode.
Monitor Single Radio
A maximum of one focus can be selected at any
given time (mutes other received radio audio by
20 dB) via a key combination.
Key Combo
1. Press and Hold: Mode Button
2. Press and Hold: PTT button
3. Release after 1 Second: All Buttons
Audio Tone
Focus: 1 Beep
De focus: 2 Beeps
Error: 3 Beeps
PTT Button to Use
• COM1: PTT1
• COM2: PTT2
• COM3: PTT3
Exit Monitor Single Radio Mode
To exit the Monitor Single Radio Mode, perform any of the
following actions:
• Key Combo
• Press any PTT button assigned to a muted radio
• Connect or disconnect any cable
Alternative State
PTT Button to Use
• COM1: PTT1
• COM2: PTT2
• COM3: PTT3
Alternative State
Most radio cables run in Open Mic Mode as the alternative
state.
Note
In Open Mic Mode, all receive audio is in the left ear only, as
the V60 is always transmitting.
Key Combo
1. Press and Hold: Mode Button
2. Short Press: PTT → PTT → PTT → PTT
3. Release: Mode Button
Alternative State
An alternative duplex state is available on
certain cables via a key combination.
Audio Tone
Alternative State On: 1 Beep
Alternative State O: 2 Beeps
Incompatible Cable: 3 Beeps