INVT CHV160A Series - Wiring Control Circuit Terminals

C.TY TNHH TỰ ĐỘNG HÓA VIỆT TRUNG 02413.281.181-
0989.984.666
Website:www.viet-trung.com.vn Đ/c:194-Nguyễn Trãi-Võ Cường-
TP.Bắc Ninh
Figure 4.11 W iring of common DC bus.
Notice: Two inverters must be the same model when connected with Common
DC bus method. Be sure they are powered on at the same time.
4.4.5 Ground Wiring (PE)
In order to ensure safety and prevent electrical shock and fire, terminal PE must be
grounded with ground resistance. The ground wire should be big and short, and it is
better to use copper wire (>3.5mm
2
). W hen multiple inverters need to be grounded, do
not loop the ground wire.
4 . 5 W i r i ng Contro l C i rc ui t Term i na l s
4.5.1 Precautions
 Use shielded or twisted-pair cables to connect control terminals.
 Connect the ground terminal (PE) with shield wire.
The cable connected to the control terminal should leave away from the main circuit
and heavy current circuits (including power supply cable, motor cable, relay and