iMars series PV energy storage inverter LCD operation instructions
42
6.4 Inverter parameter setup
Select parameter setup icon via UP/DOWN key in the main page, then press “ENT” key and enter
password validation interface. In password validation interface, there are two kinds of rights to
select, namely “user” and “admin”, select “Access as user” will enter parameter classification
interface directly, however, the menu of “admin” will not be displayed under user rights, or you can
select “Access as admin” menu and press“ENT” to enter password validation interface, input
factory password and go to parameter classification interface. All setup menus will be displayed
under admin rights.
6.4.1 Parameter classification page
The parameter classification page has six menus, corresponding to six groups of setup
parameters. Instruction for each group of menu is shown as below:
Select a menu in parameter classification page and press “ENT” key to enter corresponding
parameter selection page, select the parameter to be edited and press “ENT” key to access edition
page.
6.4.2 Parameter edit mode
First, select parameters to be edited via UP/DOWN key in password setup or parameter edit page.
For example, select password bit via UP/DOWN key in password validation page, and the object
pointed by the black arrow is the one requires editing, however, this step can be neglected if there
is only one parameter in parameter edit page. After selecting the target object, press “ENT” key to
enter value edit state while the black arrow start flashing, then you can adjust the parameter value
via UP/DOWN key. Finally, after parameter value is adjusted, press “ENT” key to finish editing, the
inverter will save parameters automatically and exit from edit state.
To Next Page
Loading...
