Inxpect ISC-B01 - Page 25

3.4.2 Inxpect Safety application usage
To use the application, the control unit must be connected to a computer with a data micro-USB cable or, if the
Ethernet port is available, an Ethernet cable. The USB cable allows to configure the system locally, whereas the
Ethernet cable allows to do it remotely.
The Ethernet communication between the control unit and the Inxpect Safety application is secured by the most
advanced security protocols (TLS).
3.4.3 Access
The application can be downloaded free of charge at www.inxpect.com/industrial/tools.
Some functions are password protected. The admin password can be set through the application and then saved
on the control unit. The available functions according to access type are presented as follows:
Available functions Access type
l Display the system status (Dashboard)
l Display the sensors configuration (Configuration)
l Restore factory default settings, if not using Ethernet connection (Settings > General)
l Back up the configuration (Settings > General)
without password
l Synchronize more control units (Settings > Multi-control unit synchronization)
l Validate the system (Validation)
l Restore factory default settings, if using Ethernet connection (Settings > General)
l Download the system log and display reports (Settings > Activity History)
l Check the current checksum for each dynamic configuration (Settings >
Configuration checksum)
l Configure the system (Configuration)
l Load a configuration (Settings > General)
l Change the admin password (Settings > Account)
l Update the firmware (Settings > General)
l Show and change the network parameters - if available (Settings > Network
Parameters)
l Show and change the Modbus parameters - if available (Settings > Modbus
Parameters)
l Show and change the Fieldbus parameters - if available (Settings > Fieldbus
Parameters)
with password
3.4.4 Main menu
Page Function
Dashboard Display main information on the configured system.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page73.
Configuration Define the monitored area.
Configure the sensors and the detection fields.
Define the dynamic configurations
Validation Start the validation procedure.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page73.
3. Get to know LBK System Series
LBK System Series| Instruction manual v1.2 SET 2021|SAF-UM-LBKBus-en-v1.2|© 2020-2021 Inxpect SpA
25